You Are Here: 811211

Short Description

SIGNALBOOST amplifier, Dual Band 824-894 MHz and 1850-1990 MHz MHz Cellular and PCS network Amplifier/ Booster model 811211 by Wilson Electronics: Plug-and-Play with included RF Inductance patch, magnet mount antenna works with all Cellular and PCS cell phones, Data cards, and networks Easy In-Home or Office booster for a single cell phone or Data card where 12 volt DC power is available

Detailed Description

• No plug-in phone adapter is needed: Connects to ALL phones and data cards with a universal RF Inductance cable using a Velcro device. One side of the inductance patch is glued to the antenna area of the cell phone near the internal antenna near the top, and the other Velcro patch has a wire coming from it to lead RF into the amplifier/ booster.
• Optional cell phone RF adapter cables are recommended whenever possible for superior transmission of signal. Connection on amplifier is an FME male connector. RF adapter needs to end in an FME female connector, so Wilson RF adapters require ACC-6 adapter.
• Wilson Electronics SIGNALBOOST Dual Band amplifier/ booster has
  10 times more power than your cell phone or laptop data card. This improves voice and data signal. 3G technologies often need the signal boost for data communications. This also reduces battery use on the cell phone.
• Cigarette Lighter Plug and extension cable included for an easy self installation.
• Optional 12 volt power supply recommended for in-building use: When you need to use this amplifier inside, use the optional RPS1203 power supply.
• 3 watts maximum output: Power control logic ensures maximum output power is within cellular standards, since Gain is cell site controlled.
• Model W-811211 works on all Digital formats of CDMA, TDMA and GSM used in the Americas.
• Note: Not compatible with iDen/ Nextel ESMR networks in the 800-824 MHz band.
• Works great in mobile, in-building and marine applications.
• Specifications: Max RF +35 dBm / +33 dBm. Noise Figure 3.5 dB nominal. Flatness 2 dB / 2 dB. Isolation (uplink/downlink) >50 dB. Power Requirements 12 Volts DC, 2 Amp minimum. Connectors FME-Male and 50 ohms. Dimensions 5 x 3.5 x 1.2 (inches) / 12.7 x 8.9 x 3 (cm). Weight 1.03 pounds / 0.468 kilograms. Model Number W-811210 operates at both radio frequency bands of 824-894 MHz and 1850-1990 MHz.
Use ACC-6 adapter (FME female to FME female) to mate this amp with any Wilson RF adapter cable.
• FCC and IC type accepted. US and foreign Patents Pending. Amplifier Installation directions are here.
• Wilson Electronics factory original One year warranty applies.